Does a tile’s P rating apply to the floor after installation?
A tile’s P rating tells you how the new material performed in a wet pendulum test under AS 4586:2013. That result remains useful after installation as a record of the product selected. To establish how a floor already in service performs today, the relevant evidence is testing at identified locations under AS 4663:2013.
What exactly did the supplier test?
A P rating is a classification from P0 to P5 derived from wet pendulum testing of a new pedestrian surface material under AS 4586:2013. The starting point when reading a supplier’s report is the specimen description.
A manufacturer may offer the same tile range in matt, polished and textured finishes, all in the same colour. If the report identifies the textured external tile, it describes that finish. Before relying on the rating, match the product code and finish in the report to the tile specified and the tile actually supplied. A shared range name can be easy to overlook when the tiles look similar.
What changes when the floor enters service?
Imagine a hotel that uses the same tile throughout its ground-floor lobby. Six months after opening, most guests have walked the same route from the entrance to the lifts. The tiles beside the planter have seen relatively little traffic. The entrance may also have received a sealer after installation.
The supplier’s report still answers the original question about the new tile. It cannot establish what effect the sealer, wear or maintenance has had on the entrance. Equally, heavier traffic alone does not establish that slip resistance has decreased. If the concern is the turn towards the lifts, that is the location to identify and assess.
Which report answers your question?
When selecting a tile, obtain the report for the proposed product and finish. When assessing a floor already in use, identify the location and the conditions of concern, then arrange measurement of the existing surface under AS 4663:2013.
A newly laid floor that has yet to enter service needs particular care when defining the scope. Tell the tester whether the surface is new and unused, what treatments have been applied, and whether the client requires a post-installation classification. The installation date alone does not determine which assessment is appropriate.
Which records should the facility manager keep?
Keep the supplier’s report with the finish schedule, records of any treatment applied after installation, and a plan identifying later on-site test locations. Label locations precisely enough for someone else to find them. “Entrance lobby, first turn towards lifts” is more useful than “ground floor”.
These records answer different questions over the life of the floor. If a concern arises later, the facility manager can establish what was specified, what changed and where performance was last measured.
Can I describe the whole lobby as P4 based on the supplier’s report?
The supplier’s P4 classification applies to the new material identified in the report. It does not establish the present performance of every part of the lobby. If the question concerns a particular entrance, ramp or pedestrian route in use, obtain evidence for that location.
Should I discard the supplier’s report once the site has been tested?
Keep both. The supplier’s report documents the original product classification. The site report records measurements at identified locations on a particular date. Before interpreting an apparent difference as a change in performance, compare the surface descriptions, methods, sliders and test conditions.
Need to establish the slip resistance of an existing floor?
Contact Zerofal to discuss testing under AS 4663:2013 and arrange a site visit.